(7.8m – 8.2m) Complete Commercial Industrial Sliding Gate Hardware Package Kit suitable for Steel, Aluminum, Metal Gates (7.8m,7.9m, 8m, 8.1m,8.2m meter gates)

The 210mm Longer overhead bracket allows for a full adjustment up to maximum total gate thickness of 115mm. This is typically the go to in most cases when using an overhead bracket and roller arrangement as it allows for all standard gate thickness and also surface mounted horizontally clad gates or gates that need a larger set back away from the post. It is constructed of DUAL C channels providing the best rigidity and with no flex under load.

Best suited for heavier gates the for point roller system shares the load across the four rollers (as opposed to two) It can support an effective gate thickness from 60-105mm with adjustment in the slotted channels. The secondary plate optionally can be used to additionally support bracket by welding or screwing to a secondary support post creating a tunnel style installation.

Just like System A, System B is also best suited for heavier gates as the for point roller system shares the load across the four rollers (as opposed to two). The difference is the greater adjustment allowing for gate thicknesses from smallest possible all the way up to 110mm, Also as per system A the adjustment occurs within the slotted channel. The secondary plate optionally can be used to additionally support bracket by welding or screwing to a secondary support post creating a tunnel style installation.

This system requires a support post behind the gate on the inside, the C channel option chosen ideally should be same material as the post (Both Steel and Aluminum choices are available).

On the back of the gate a welded 40×40 angle (or screw on Z section, available as an optional item) slides through the nylon block.

Best suited for gates on a grade where the guide system must follow UP/DOWN during the gates operation, Suitable for gates where there is overhead protrusions such as spears, suitable for gates with face mounted cladding to the frame.

White and Black nylon block options are available.

80mm Catcher is used with gates not exceeding 70mm (typically externally face cladded gates). It has a top cap to prevent the gate from being lifted when in the closed position.

55-90mm Adjustable entry catcher, suitable for gates from 40mm to 80mm total thickness requiring a roller entry point due to wind loading or otherwise). Highly effective option for cladded gates prone to wind loading.

55-90mm Adjustable entry catcher, suitable for gates from 40mm to 80mm total thickness requiring a roller entry point due to wind loading or otherwise). Highly effective option for cladded gates prone to wind loading. The key additional feature of this catcher is the ability to adjust its alignment with the offset bracket making it perfect for when the posts side face does not align with the gate.

80mm DOUBLE WHEEL

The 800mm bearing wheels screw (or weld) directly to the bottom of the gate tubing without any need for cutting, the supported load between the set on each end of the gate is 900KG.

100mm DOUBLE WHEEL

The 100mm bearing wheels screw (or weld) directly to the bottom of the gate tubing without any need for cutting, the supported load between the set on each end of the gate is 1100KG.

The sliding gate ground track is formed from galvanized steel to the R10 profile, this profile is proven to be the smoothest operation for the gate wheels without any negative characteristics like the older v groove designs.

The track is secured to the driveway using plugs and screws or knock in’s such as anchor nails, its important to use a fixing that does not protrude greater than 3-4mm to prevent contact with the gate wheels.

✓ Galvanized Steel
✓ Elongated 6mm holes allow for adjustment before final tie down
✓ Suits all R10 gate wheels

The gate stopper is a crucial part to any sliding gate installation, the stop is installed at the end of the open position to prevent the gate from being opened past the normal open point which prevents the sliding gate from coming off the track (or out of the top guiding system.

✓ Rubber Bumper
✓ 145mm High
✓ 10mm stem and 6mm base steel thickness